Corvallis Ice Dams: Melting on Days It Never Thaws
The pack at this elevation is deep enough to act as its own insulation, which means the surface melts under sun while the base stays locked. Water released at the top has to travel through and under all of it.
Depth makes it worse. A Benton County roof can carry several feet of pack, and all of that is a reservoir sitting above an eave that never sees sun.
Ice-barrier practice in Benton County
Mountain jurisdictions across Benton County generally require ice-barrier membrane well up the roof plane, not just the first course, along with snow retention on metal roofs above entries and walkways.
How a Corvallis Steam Call Runs, Start to Finish
Nothing gets touched until the roof has been walked and photographed. The crew finds every dam, locates where water is getting in, shows you, and gives you the crew-hour rate and a time estimate before the equipment comes off the truck.
Removal then works from the worst point outward, so water starts draining early rather than at the end. Gutters and downspouts frozen solid get steamed through in the same visit — leaving them means the eave dams again within days.
What the dam has already done to the gutter and fascia
Ice expands as it forms, and a trough packed solid pushes the gutter away from the fascia a little more every cycle. By the time the dam is thick enough to leak, the hangers are often pulled, the back of the trough has lifted, and the fascia board behind it has been wet for weeks.
None of that is visible until the ice is off. It gets photographed when it appears, because a bent gutter found in February is a great deal easier to argue about with a carrier than one discovered in May.
What steam actually does
A steam unit delivers water at roughly 290°F at a pressure low enough to rest your hand in the plume. It cuts a channel straight through the ice and lifts the dam off in sections, right down to the shingle. The heat does the work, not force, so granules, seal strips and flashing come through untouched.
That is the whole difference between steam and the hot pressure washers often sold as steam. A pressure washer cuts ice fast because of its pressure — and that same pressure strips the granules off asphalt shingles and drives water up under the courses. One method removes ice. The other removes ice and roof.
Why the dam formed in the first place
Ice dams are a heat problem wearing a weather costume. Warm air escaping into the attic melts snow on the upper roof; that meltwater runs to the eave, which hangs past the heated envelope and stays below freezing; it refreezes there, and the ridge of ice grows a layer every cycle. Removal is the emergency fix. Before the crew leaves you will know which part of your attic is feeding it.
| Pricing model | Billed by the crew hour, rate quoted before dispatch |
|---|---|
| Removal method | Low-pressure steam only. No chipping, salt or pressure washing. |
| Typical scope | Steam, 8-16 crew hours typical |
| Coverage area | Corvallis and Benton County |
| Dispatch window | 24 to 48 hours in mountain terrain |
| Primary climate stressor | Solar melt on deep pack, shaded eaves |
| Documentation | Dated before and after photos, written scope in Xactimate line items |
Neighborhoods and Towns We Reach From Corvallis
Crews working Corvallis cover the adjoining communities on the same route — Philomath, Tangent and Shedd — so a storm week usually means one truck handling several addresses in Benton County rather than separate trips.
Nearest hub towns with their own crew pages: Albany, Salem, Keizer, Eugene, Springfield, McMinnville.
Coverage runs across Corvallis and the nearby towns all winter, and capacity is surged into whichever Oregon market the storm actually hits.
Active leak at an address in Corvallis? (888) 561-9664 reaches dispatch directly. Interior water moves a job to the front of the day.
