Chicago Ice Dams: Why a Few Inches Is Enough
What catches people out in Cook County is that the snow looks harmless. Two or three inches reads as nothing, and it builds ice on an eave just as effectively as a northern storm given enough cycles.
The building stock has no margin for it. Because the winters here read as mild, attics tend to be under-insulated, eave details are less considered, and ice barrier is as often absent as present on a roof in Chicago.
Ice-barrier practice in Cook County
The residential code Illinois follows requires eave ice barrier on new work, and Cook County enforces it. The variable on any given house is simply when it was last roofed.
How a Chicago Steam Call Runs, Start to Finish
Nothing gets touched until the roof has been walked and photographed. The crew finds every dam, locates where water is getting in, shows you, and gives you the crew-hour rate and a time estimate before the equipment comes off the truck.
Removal then works from the worst point outward, so water starts draining early rather than at the end. Gutters and downspouts frozen solid get steamed through in the same visit — leaving them means the eave dams again within days.
What happens after the ice is off
Once the eave is clear and water is draining, the crew walks the interior with you where there is visible damage and says plainly whether it needs drying. Wet insulation and a damp ceiling cavity do not resolve themselves in a cold Chicago February.
If it does, that is a separate scope and it gets written separately — nobody is upsold a dryout on the strength of one damp patch.
Why a drainage channel is not removal
Cutting a few channels through a dam so water can get past is quick and it is sometimes sold as ice dam removal. It drains the roof for as long as the channels stay open, which in a Chicago cold snap can be a single night before they close again.
Removing the dam means taking the ice off down to the shingle along the whole affected run, so the eave can drain the way it was built to. It takes longer and it is the only version that holds.
Why the gutter has to be cleared in the same visit
A dam sitting above a gutter packed solid with ice is only half the problem. Clear the eave and leave the trough frozen, and the next day's meltwater has nowhere to run — it backs up onto the roof and the dam rebuilds from the bottom.
Crews steam the trough and the downspout through to daylight on the same visit. It adds time, which is why the hour estimate given on the phone accounts for it, and it is the difference between a fix and a repeat visit in Chicago the following week.
| Pricing model | Billed by the crew hour, rate quoted before dispatch |
|---|---|
| Dispatch window | Same day to 24 hours |
| Service | Ice dam removal in Chicago, IL |
| Removal method | Low-pressure steam only. No chipping, salt or pressure washing. |
| Typical scope | Steam, 4-8 crew hours typical |
| Coverage area | Chicago and Cook County |
| Local ice-barrier practice | Eave membrane on new work, often absent |
Where We Dispatch Around Chicago
Crews working Chicago cover the adjoining communities on the same route — Forest Park, Lincolnwood, Elmwood Park, River Forest and Riverside — so a storm week usually means one truck handling several addresses in Cook County rather than separate trips.
Nearest hub towns with their own crew pages: Cicero, Oak Park, Berwyn, Hanover Park, Skokie, Evanston.
Crews cover Chicago and the surrounding Cook County towns through the whole season, and during a freeze event they run from first light until dark.
Active leak at an address in Chicago? (888) 561-9664 reaches dispatch directly. Interior water moves a job to the front of the day.
